2. The Use OS-Defined restart policy is set to YES and the operating system
has NO automatic restart policy.
Refer to “Service Processor Reboot/Restart Recovery” on page 4-27.
Call-Out before restart (Enabled/Disabled) If a restart is necessary due to a
system fault, you can enable the Service Processor to call out and report the
event. This item is valuable if the number of these events becomes excessive,
signalling a bigger problem.
Service Processor Functions and Features
The following section discusses some of the Service Processor functions and
features more fully.
The IBM RS/6000 7025 F50 Series supports the following functions:
Built-in Functions Initialization and Test Service Processor Basic
Instructions Test (BIST)
JTAG System Chip
Initialization
Error Data Collection BIST/POST errors and status
Checkstop FIR data logout
Machine check logout
Configuration CPU Complex validation
VPD Collection
System Management Reset and Reboot on System
Firmware fail
Reboot on system failure
4-24 IBM RS/6000 7025 F50 Series User's Guide
To Next Page
Loading...
