Control Enclosure 1: FlashSystem 5015 or the FlashSystem 5035
Left Node Canister 1
Link Details
Right Node Canister 2
Port 1 Port 2 Port 3 Port 4 Port 1 Port 2 Port 3 Port 4
Switch
Port
Speed
Control Enclosure 2: the FlashSystem 5035
Left Node Canister 1
Link Details
Right Node Canister 2
Port 1 Port 2 Port 3 Port 4 Port 1 Port 2 Port 3 Port 4
Switch
Port
Speed
SAS connections
Record the SAS port connections in the following table. SAS connectivity to hosts is provided by the optional 4-port 12 Gbps SAS adapter.
Control Enclosure 1: FlashSystem 5015 or the FlashSystem 5035
Left Node Canister 1
Link Details
Right Node Canister 2
Port 1 Port 2 Port 3 Port 4 Port 1 Port 2 Port 3 Port 4
Switch
Port
Speed
Control Enclosure 2: the FlashSystem 5035
Left Node Canister 1
Link Details
Right Node Canister 2
Port 1 Port 2 Port 3 Port 4 Port 1 Port 2 Port 3 Port 4
Switch
Port
Speed
Management and service address worksheet
Use the following table to record the management address and service addresses for each control enclosure . The primary system address
is bound to Ethernet port 1. The secondary system address, if specied, is bound to Ethernet port 2. Both IPv4 and IPv6 addresses can be
used. Specify the type of installation and the serial number (S/N) of the control enclosure.
• If you are installing a new system installation, designate new, unused IP addresses.
• If you are adding an I/O group (control enclosure) to an existing system, use the management address of the existing system.
Control Enclosure S/N:
Are you adding this control enclosure to an existing system? ❐ Yes ❐ No
Address Type IP Address Network Mask Default Gateway
Primary system address (required)
Secondary system address (optional)
Node canister 1 service address (required)
Node canister 2 service address (required)
3
To Next Page
Loading...
Need help?
General
