IBM IntelliStation A Pro User Manual

install a drive or PCI-X adapter, save the EMC shield and filler panel from the
bay or the PCI-X adapter slot cover in the event you later remove the drive or
adapter.
v For a complete list of supported options for your computer, go to
http://www.ibm.com/pc/; then, select your country and navigate to the list of
options for your computer.
Preinstallation
steps: Some of these steps are required only the first time you
install a hard disk drive in a specific bay.
1. Read the safety information beginning on page v,, the guidelines in “Handling
static-sensitive devices” on page 11, and the documentation that comes with
your drive.
2. Make sure that you have all the cables and other equipment specified in the
documentation that comes with the drive.
3. Choose the bay in which you want to install the drive.
4. Check the instructions that come with the drive to see if you need to set any
switches or jumpers on the drive. If you are installing a SCSI device, make sure
to set the SCSI ID for that device.
Installing
a drive in bay 2: Complete the following steps to install a drive in bay
2:
1. Follow the instructions in “Preinstallation steps.”
2. Turn off the computer and all attached devices (see “Turning off the computer”
on page 41); then, disconnect all power cords and external cables.
3. Remove the side cover (see “Removing the cover” on page 15).
4. Remove the front bezel (see “Removing the bezel” on page 17).
5. Remove the support bracket (see “Removing and installing the support
bracket” on page 16).
6. Use a screwdriver to pry the filler panel and EMC shield away from the
computer.
Note: If you are installing a drive that contains a laser, review the following
safety precaution.
22 IntelliStation A Pro Type 6224: Installation Guide

IBM IntelliStation A Pro Specifications

General

Brand	IBM
Model	IntelliStation A Pro
Category	Desktop
Language	English