f. The Configuration ID displayed is defined as follows:
Table 1. Configuration ID
ID Model
80 FC 5065, FC 5066
81 FC 5074, FC 5079
82 FC 9079
84 FC 5078, FC 0578
90 FC 5075
91 Model 270 without an expansion unit and without a removable processor
92 Model 270 without an expansion unit and with a removable processor
93 Model 820
95 Model 270 with an expansion unit and without a removable processor
96 Model 270 with an expansion unit and with a removable processor
Is the correct configuration ID displayed for the tower selected?
v No: Continue with the next step.
v Yes: Go to step 6 (See page 343).
5. Perform the following to set frame Configuration ID:
Note: The system or frame that will display the ID MUST be powered down with ac applied.
a. Select Function 07 on the system control panel and press Enter. An 07** will display.
b. Use the arrow keys to increment / decrement to subfunction A9. An 07A9 will display.
c. Press Enter. An 07A9 00 will displayed.
d. Use the arrow keys to increment / decrement to the frame address of the box you want to set the
Configuration ID (usually 02, 03, ... for the towers, 01 for system unit frames). An 07nn will display
where nn is the frame address.
e. Press Enter. An 07nn 00 will display.
Note: The display on the addressed frame should now be blinking on and off (non-system unit
frame only).
f. Select the correct Configuration ID from the following table:
Table 2. Configuration ID
ID Model
80 FC 5065, FC 5066
81 FC 5074, FC 5079
82 FC 9079
84 FC 5078, FC 0578
342 iSeries: iSeries Server 270, 800, 810, 820, 825, 830, 840, 870, 890, SB2, and SB3 Hardware Problem Analysis and
Isolation
To Next Page
Loading...
Need help?
General