IBM iSeries 820 Hardware Problem Analysis And Isolation

v Yes: Replace the battery power unit charger (see Type, model, and part number list for part
number).
This
ends the procedure.
v No: This ends the procedure.
Instructions for Models 800, 810, 825, 870/890 (FC 9094)
1. Is the SRC 1xxx 1B01, 1B02, 1B03, 1B04, 1B06, or 1B07 on a Model 800 or 810 system unit?
v No: Continue with the next step.
v Yes: Perform “Power PIP4” on page 153 to isolate the failing item. The failing item may be one of
the following parts:
– Any part on the system power bus
– Models 800 and 810 - regulator card R01 (see Locations - Models 800 and 810 for part number)
This
ends the procedure.
2.
Is the SRC 1xxx 1B05?
v No: Continue with the next step.
v Yes: For Models 800 and 810 replace regulator card R01 (see Locations - Models 800 and 810 for
part number)
This ends the procedure.
3.
Is the SRC 1xxx 1B0A, 1B0B, 1B0C 1B0D, 1B0E, or 1B0F on a Model 825?
v No: Continue with the next step.
v Yes: Perform “Power PIP5” on page 158 to isolate the failing item. The failing item may be one of
the following parts:
– Any part on the system power bus.
– Power supply P01 or P02 (see Locations - Model 825 )
This ends the procedure.
4. Is the SRC 1B11, 1B12, 1B13, 1B14, 1B16, 1B17 on a Model 800 or 810 with FC 7116 system unit
expansion, or SRC 1xxx 1B01, 1B02, 1B03, 1B04, 1B05, 1B06 or 1B07 on an FC 5075 or FC 5095
I/O Tower?
v No: Continue with the next step.
v Yes: Perform “Power PIP9” on page 172 to isolate the failing item. The failing item may be one of
the following parts (see Type, model, and part number list for part number):
– Any part on the expansion power bus.
– A power supply:
- FC 7116: Power supply P02
- FC 5075: Power supply P01 or P02
- FC 5095 or FC 0595: Power supply P01 or P02
5. Is the SRC 1xxx 1B01, 1B02, 1B03, 1B04, 1B05, 1B06 or 1B07 on an FC 5074, FC 5078, FC 0578,
FC 5079, FC 5088, FC 0588, FC 5094, FC 5294, FC 8093, FC 8094, or FC 9094 expansion?
v No: Continue with the next step.
v Yes: Choose from the following options:
– For FC 5074, FC 5079, FC 5094, FC 5294, FC 8093, FC 8094, or FC 9094, perform “Power
PIP6” on page 160 to isolate the failing item. The failing item may be one of the following parts
(see Locations and addresses ).
- Any part on the system power bus.
- Power supply P00 (dual line cord)
- Power supply P01 (single line cord)
- Power supply P01 (dual line cord)
- Power supply P02 (single line cord)
Analyze hardware problems 423

IBM iSeries 820 Specifications

General

Brand	IBM
Model	iSeries 820
Category	Server
Language	English