Reference Code Description/Action Perform all actions before exchanging Failing Items Failing Item
69F0 Bus Expansion Adapter failed
Contact has been lost to the bus.
Perform BUS-PIP1.
FI00180
FI00182
FI00203
FI00056
FI00205
LBUSADP
AJDG301
69F8 Bus Expansion Adapter failed
An optical link initialization failure occurred. The number and
configuration of the system buses can not be determined.
Perform BUS-PIP1.
FI00180
FI00203
FI00182
FI00186
FI00057
AJDG301
7001 ISDN call in rejected GG3COMM
7002 Lines not selected GG3COMM
7003 Network interfaces not selected GG3COMM
7004 TCP/IP informational error
This reference code is logged when the TCP/IP Attribute “Log Protocol
Errors” is set, and the TCP/IP System LIC “silently discards” an inbound
datagram. “Silently discard” is defined to mean discard the received
datagram without reporting an error to the originating host device.
Examples of such datagrams are those with checksums or destination
addresses which are not valid.
This reference code is for information only. Normally no action should be
taken as a result of this reference code. It is generated in order to assist
with remote device or TCP/IP network problem determination.
7055 Statistics were logged, no service action required
This reference code is logged for information only.
7100 APPN session initiation attempt has timed out
This reference code is used to indicate that LIC timed out on a request to
initiate a session.
The user must run problem analysis for this reference code. If this indicates
a software problem, the user should dial IBM Software Support for
assistance.
The Problem Determination Procedure (PDP) will indicate whether the
original timeout condition still exists and what the corrective actions
should be.
AJDG301
GG3PL03
GG3PL01
GG3PL02
7101 APPN session initiation attempt has failed
This reference code is used to indicate that LIC attempted to satisfy a
session initiation request, but some failure condition was detected by LIC.
The failure condition could be a configuration or operational problem in
the network.
The user must run problem analysis for this reference code. If this indicates
a software problem, the user should dial IBM Software Support for
assistance.
The Problem Determination Procedure (PDP) will indicate whether the
original timeout condition still exists and what the corrective actions
should be.
GG3PL04
GG3PL05
GG3PL06
AJDG301
B6xx (including A6xx)
294
iSeries: iSeries 270, 800, 810, 820, 825, 830, 840, 870, 890, SB2, and SB3 Analyze Hardware Problems (System Reference
Codes)
To Next Page
Loading...
Need help?
General