IBM MT 2369 User Manual

Symptom or error FRU or action, in sequence
0195
Security
hardware tamper
detected
1. Enter IBM BIOS Setup
Utility by entering
supervisor password, and
select “Password” -->
“IBM Security Chip” -->
“Clear IBM Security Chip”
to clear this error.
2. Security chip.
3. System board.
0196
Security
hardware removed
1. Enter IBM BIOS Setup
Utility by entering
supervisor password, and
select “Password” -->
“IBM Security Chip” -->
“Clear IBM Security Chip”
to clear this error.
2. Security chip.
3. System board.
0197
Invalid
remote change
requested.
The remote configuration for
the security chip has failed.
Confirm the operation and try
again.
0199
System
Security—IBM Security
password retry count exceeded.
1. Run IBM BIOS Setup
Utility, and then save
current setting by
pressing F10.
2. System board.
01C8
More
than one modem devices
are found. Remove one of
them. Press <Esc> to continue.
1. Remove either a Mini-PCI
Card. Otherwise, press
Esc to ignore the warning
message.
2. System board.
01C9
More
than one Ethernet devices
are found. Remove one of
them. Press <Esc> to continue.
1. Remove the Ethernet
device that you installed;
or press Esc to ignore the
warning message.
2. System board.
0200
Failure
Fixed Disk—Fixed disk
is not working or not configured
properly.
1. Reseat the hard disk
drive.
2. Load Setup Defaults in IBM
BIOS Setup Utility.
3. Hard disk drive.
4. System board.
(continued)
Symptom-to-FRU index
ThinkPad X40 61

IBM MT 2369 Specifications

General

Brand	IBM
Model	MT 2369
Category	Desktop
Language	English