5. If you have a stand-alone server, install the front door, if necessary, by completing the following steps:
a. Hold the front door at an approximate 120 degree angle to the system as shown in the figure.
b. Follow the direction of the arrow as shown in the figure to attach the door.
c. Close the door.
Note: If you must remove the front door, complete the following steps:
a. Open the front door by grasping the door handle and pulling the door at approximately a 120
degree angle to the system.
b. Pull the door away from the cover.
6. You have now completed the steps to install your server.
46 Power Systems: Installing the IBM Power System S814 (8286-41A)
To Next Page
Loading...
Need help?
General