IBM Proprinter

Operator
Note!
Before
you
ship
the
printer
to
an
IBM
Service/Exchange
Center
,
remove
and
keep:
Ribbon
cartridge
Power
cord
Printer
cable
If
You
Are
Still
Having
Printer
Problems
CAUTION
The print head stays hot after continuous use. Allow the
print head to cool before you touch the print head.
Do
each
step
in
order
.
Try
to
run
the
self-test
after
each
step.
See
"How
to
Test
the
Printer
(Self
Test)"
on
page
2-18.
1.
Run
the
test
procedures
for
your
computer.
2.
Make
sure
your
printer
power
cord
is
correctly
connected
at
both
ends.
a.
Ensure
the
printer
power
cord
is
completely
plugged
into
a
wall
outlet.
b.
Ensure
the
printer
power
cord
is
plugged
into
the
printer.
c.
Ensure
any
other
items
plugged
into
the
same
wall
outlet
are
operating.
d.
Make
sure
the
wall
outlet
does
not
turn
off
with
the
wall
switch
.
e.
Plug
the
printer
into
a
different
wall
outlet.
3.
Set
the
power
switch
to
Off
(0).
4.
Disconnect
the
printer
cable
(from
your
computer
or
terminal)
at
the
printer
end.
5.
Run
the
self-test
.
See
"How
to
Te
st
the
Printer
(Self
Test)''
on
page
2-18.
If
the
self-test
fails
,
go
to
the
next
step.
5-4