To enter the graphical System Management Services instead of the Open Firmware
command line, you must press the F1 key
after the keyboard icon appears
during
startup.
If you have pressed the F1 key, the System Management Services appears after the
initialization and power-on self test (POST) are complete.
Note: If you have installed a privileged-access password, you are prompted for this
password before gaining access to the System Management Services menu.
After the System Management Services starts, the following screen appears.
System Management Services
Config
Multiboot
Utilities
Exit
You may also press F8 here to enter the OK> prompt.
6-2 Service Guide
To Next Page
Loading...
