7. Remove the memory module by pushing the tabs out on the memory connectors.
Push Locking Tabs
Out to Release Memory
Module
1
2
1
Replacement of Memory Modules
1. With one hand, touch any metal surface of the chassis to minimize static
electrical charges, and them pick up the memory module.
2. Locate the memory module connector on the memory card.
Note: Memory modules must be installed in pairs and in the correct slot
configuration. (Slots J1 and J2, J3 and J4, J5 and J6, etc.)
3. Insert the memory module firmly into the connector.
Chapter 7. Removal and Replacement Procedures 7-15
To Next Page
Loading...
