Configuration File Selection
1. Does your modem respond to the extended command set (prefixed with &)?
If yes, go to 3
If not, continue with 2 below.
2. Does your modem respond to:
a. ATZ reset command, or
b. ATZn reset commands, where n can be 0, 1, etc.?
If ATZ, configuration file modem_z.cfg is recommended.
If ATZn, configuration file modem_z0.cfg is recommended.
If yes, go to 5 on page A-44
If not, continue with 3 below.
3. Does your modem command set include a test for v.42 error correction at the
remote modem (often called "Auto-Reliable Mode")?
If yes, and enabled is the default, this test must be disabled. See “Customizing
the Modem Configuration Files” on page A-44 for more information.
If not, continue with Step 4 on page A-44.
Appendix A. Service Processor Information A-43
To Next Page
Loading...
