4. Does your modem respond to:
a. AT&F reset command, or
b. AT&Fn reset commands, where n can be 0, 1, etc.?
If AT&F, configuration file modem_f.cfg is recommended.
If AT&Fn, configuration file modem_f0.cfg or modem_f1.cfg is recommended,
depending on which provides the hardware flow control profile.
5. Selection is complete. If you find it necessary to adjust any of these
configuration files, do so with reference to the manual that came with your
modem.
2
Choose settings that enable hardware flow control and respond to DTR.
Examples
*
Ring interrupt only on first ring.
Customizing the Modem Configuration Files: You can create your own
modem configuration file(s) or modify the samples provided. After you customize
your modem configuration files, you MUST access them via the Configure Remote
Maintenance Policy Service Aid rather than from the Service Processor menus.
Modem Setup Z Setup Z0
(Rare)
Setup F Setup F0 Setup F1
AT&T Data Port 2001
*
X
Bocamodem 1440E X
Hayes Smart Modem 300 X
IBM 5841 X
IBM 5843 X
IBM 7851 X
IBM 7852-010 X
IBM 7855 X
US Robotics
33.6K Sportster
X
Zoom V.32 X
2
Some older modems do not respond to the commands X or &R1. You should edit out these
commands from the modem configuration file if yours is such a modem. See your modem manual for
more information.
A-44 Service Guide
To Next Page
Loading...
