Step 6: Connect the Keyboard and Mouse
Rear of System Unit
If a wrist/palm rest was included with your keyboard and you wish to attach it, refer
to keyboard documentation for installation instructions.
Step 7: Connect the Serial and Parallel Devices
If you have a parallel device (such as a printer), connect it to the parallel connector.
If you have one serial device, connect it to the serial connector S1. If you have an
ASCII terminal, you must connect it to the serial connector S1. An additional serial
device may be connected to the S2 connector.
Two 9-to-25-pin serial converters are provided with your system unit to increase
serial device compatibility.
Parallel
Connector
Serial
Connectors
S2
S1
3
To Next Page
Loading...
