8. Remove the old voltage regulator card by pushing down on the latches as
shown. Lift the card up and out of the system unit.
9. Store the voltage regulator card in a static-protective package.
10. Install the new voltage regulator card, pressing down until the latches click into
place.
11. Before handling the PowerPC 604e microprocessor, read “Safety Considerations”
on page 4-2 and “Handling Static Sensitive Devices” on page 4-3.
Lift the processor socket lever up and remove the existing processor. Store the
processor in a safe place.
Chapter 4. Installing and Removing Options 4-57
To Next Page
Loading...
