plate stamped with a number 1 should face upward. If you are installing a
POWER GXT800P in a Model 240, the side of the plate stamped with a
number 2 should face upward.
b. Attach the support plate to the disk drive bracket as shown. The screw
should thread into the post on the support plate.
7. Touch the static-protective package containing the option to any unpainted metal
surface on the system unit; then remove the option from the package.
8. If you are installing a POWER GXT3000P adapter, you must first install a
support bracket loosely to the card.
9. Slide the adapter through the opening and press it
firmly
into the socket until the
gold connector is fully inserted in the socket
10. Replace the expansion-slot screw.
Chapter 4. Installing and Removing Options 4-75
To Next Page
Loading...
