4. Disconnect the signal and power cables from any drives installed in bay 4 or bay
5.
Note: Removing cables from a drive in bay 4 is shown to illustrate this
procedure.
5. Remove the disk drive bracket assembly from the system unit.
Note: Any adapters installed in slot 5 may have to be temporarily removed in
order to remove the disk drive bracket. Refer to “Removing Adapters” on
page 4-80 for adapter removal instructions.
What to do next?
To install or remove a drive in bay 2 or 3, continue with the next step.
To install or remove a drive in bay 4 or 5, go to step 23 on page 4-98.
Chapter 4. Installing and Removing Options 4-89
To Next Page
Loading...
