30. Connect the signal and power cable to each of the installed drives. Connecting
cables to the drive in bay 4 is shown to illustrate this procedure.
Note: If you have difficulty connecting a cable, turn the cable connector over
and try again. Cable connectors are keyed and connect only one way.
These cables have multiple connectors so that one cable can connect to
more than one drive.
31. Reinstall any adapters you may have removed.
32. Go to “Device Records” on page A-3 and update the system information. Return
here to continue.
4-100
7043 43P Series User's Guide
To Next Page
Loading...
