Installing a Security Tether
A security tie-down option is available to help prevent theft of your system unit. For
easy relocation of your system unit, obtain a lock, such as a combination lock or
padlock.
Before you begin:
Obtain the following:
– A flat-blade screwdriver
– An adjustable wrench (for the Model 140 and Model 240)
– A 19 mm (3/4-inch) U-bolt or wire rope (similar to National Manufacturing
No. 3230, Stock No. 176-735)
– Threaded nuts (Model 140 and Model 240) or bolts (Model 150) that fit
the U-bolt
– A security cable
– A lock, such as a combination lock or a padlock.
Read “Safety Considerations” on page 4-2 and “Handling Static Sensitive
Devices” on page 4-3.
Turn off the system unit.
Disconnect all external cables and power cords.
Remove the system unit cover (see “Removing the Cover” on page 4-4).
1. Remove the plastic plug from the rear panel.
2. Install the U-bolt.
4-106 7043 43P Series User's Guide
To Next Page
Loading...
