open firmware command line 3-43
operating considerations
standalone and online
diagnostics 5-1
operator panel display 1-10
ordering
publications xxi
replacement keys A-2
P
parallel port 1-11, 4-116
parameters
default, configuration A-3
part numbers
keys A-2
serial A-1
physical location codes 6-1
POST indicators 2-1
power LED 2-5
power switch 2-5
power switch, location 1-10
power-on light 1-10
Power-On Self Test 2-1
preface xxi
preparing
for installation 1-2, 4-4
for setup 1-2
product
identification numbers A-1, A-2
internal and external options A-3
name A-1
product disposal xix
protecting the system unit 1-2
publications
ordering xxi
R
rear view 4-116
records, device A-3
recycling xix
related publications xxi
replacing
keys A-2
replacing battery 4-108
reset button 1-10
run exercisers 9-30
running the online diagnostics in
concurrent mode 5-12
running the online diagnostics in
maintenance mode 5-12
running the online diagnostics in
service mode 5-10
running the standalone
diagnostics 5-13
S
safety considerations 4-2
safety requirements
considerations 4-2
electrical xv
general information 1-2
laser compliance statement xvi
SCSI (small computer system interface)
bus analyzer 9-32
connector 4-116
device identification and
removal 9-34
SCSI port 1-11, 4-116
sequence, startup 3-9
serial numbers
keys A-1, A-2
server A-1
setting
voltage switch 1-2, 1-15
setting up RS/6000 7043 43P
Series 1-1
X-4
7043 43P Series User's Guide
To Next Page
Loading...
