Chapter 2. Using the System Unit
Starting the System Unit
1. Turn on all attached devices.
2. Turn on the system unit.
3. If power does not come on when you turn on the system unit, ensure that the
power cord, located at the back of the system unit, is plugged into a grounded
electrical wall outlet. If this does not solve the problem, go to Chapter 8,
“Hardware Problem Determination” on page 8-1.
When you turn on the system unit, the Power LED comes on and the system starts a
POST (power-on self test). During this test, the disk status LED flashes intermittently.
The system beeps a short beep, and progress indicators appear on the operator
panel display.
Copyright IBM Corp. 1996, 1998 2-1
To Next Page
Loading...
