IBM RS/6000 H50 - Page 115

Table 3-5 (Page 3 of 10). Firmware Checkpoints.
Checkpoint Description Action/
Possible Failing FRU
E138 Create options node See the note on 3-30.
E139 Create aliases node and system
aliases
See the note on 3-30.
E13A Create packages node See the note on 3-30.
E140 PReP style load See the note on 3-30.
E149 Create boot mgr node See the note on 3-30.
E14C Create terminal-emulator node See the note on 3-30.
E14D Load boot image See “E1xx Code Boot Problems” on
page 3-46.
E14E Create client interface
node/directory
See the note on 3-30.
E14F NVRAM validation, config variable
token generation
See the note on 3-30.
E150 Create host (primary) PCI controller
node
See the note on 3-30.
E151 Probing primary PCI bus 1. PCI Adapters
2. I/O board.
If a network adapter or I\O board is
replaced, see 3-1.
See the note on 3-30.
E152 Probe for adapter FCODE, evaluate
if present
1. PCI Adapters
2. I/O board.
If a network adapter or I\O board is
replaced, see 3-1.
See the note on 3-30.
E153 End adapter FCODE,
probe/evaluation
See the note on 3-30.
E154 Create PCI bridge node See the note on 3-30.
E155 Probe PCI bridge secondary bus 1. PCI Adapters
2. I/O board.
If a network adapter or I\O board is
replaced, see 3-1.
See the note on 3-30.
E156 Create PCI ethernet node See the note on 3-30.
E15A Create 64 bit host (primary) PCI
controller node
See the note on 3-30.
E15B Transferring control to Operating
System (service mode boot)
See “E1xx Code Boot Problems” on
page 3-46.
Chapter 3. Error Code to FRU Index 3-35