2. Loosen the screws that hold the disk drive cover to the drawer and remove the
the disk drive cover from the drawer, storing it in a safe place.
3. Each hot swap disk drive you plan to replace must have the hot swap SCSI disk
drive carrier attached.
Attention: Handle the hot swap disk drive with care as it is very fragile and can
be easily damaged if exposed to shock, electrostatic discharge, or rough han-
dling.
4. It is recommended that you install the hot swap disk drive in the next unused
position of bank B first, and then bank C.
Attention: Attaching SCSI address jumpers on the hot swap disk drive rather
than using the automatic ID furnished by the backplane is not advised. Attaching
jumpers can cause service problems, multiple drives at the same address, or
confusion locating the correct drive.
7-14
RS/6000 Enterprise Server Model H50 Installation and Service Guide
To Next Page
Loading...
