IBM RS/6000 H50 - Page 88

Table 3-1 (Page 7 of 26). Firmware Error Codes.
Error Code Description Action / Possible Failing FRU
2501000A Flash write protected. 1. Turn off, turn on system unit, retry.
2. Replace I/O board. (See notes on
3-1.)
25A0xxx0 L2 Cache controller problem. 1. Replace the CPU card.
2. Replace the System board.
See error code 2B2xxx22 for xxx defi-
nitions.
25A0xxx1 L2 Cache controller problem. 1. Replace the CPU card.
2. Replace the System board.
See error code 2B2xxx22 for xxx defi-
nitions.
25A1xxx1 L2 SRAM failure Replace the CPU card.
See error code 2B2xxx22 for xxx defi-
nitions.
25A80000 Initialization failed, device test failed. Refer to Action under error code
25A80xxx.
25A80001 Init-nvram invoked, ALL of NVRAM ini-
tialized.
Refer to Action under error code
25A80xxx.
25A80002 Init-nvram invoked, some data parti-
tions may have been preserved.
Refer to Action under error code
25A80xxx.
25A80011 Data corruption detected, ALL of
NVRAM initialized.
Refer to Action under error code
25A80xxx.
25A80012 Data corruption detected, some data
partitions may have been preserved.
Refer to Action under error code
25A80xxx.
25A80100 NVRAM data validation check failed. Turn off, turn on system unit and retry
the operation before replacing any
system component. Refer to Action
under error code 25A80xxx.
25A80201 Unable to expand target partition while
saving configuration variable.
Refer to Action under error code
25A80xxx.
25A80202 Unable to expand target partition while
writing error log entry.
Refer to Action under error code
25A80xxx.
25A80203 Unable to expand target partition while
writing VPD data.
Refer to Action under error code
25A80xxx.
25A80210 Setenv/$Setenv parameter error - name
contains a null character.
Refer to Action under error code
25A80xxx.
25A80211 Setenv/$Setenv parameter error - value
contains a null character.
Refer to Action under error code
25A80xxx.
3-8 RS/6000 Enterprise Server Model H50 Installation and Service Guide