Table 3-1 (Page 8 of 26). Firmware Error Codes.
Error Code Description Action / Possible Failing FRU
25AA0xxx EEPROM problems EEPROM problem resolution:
1. Ensure that the EEPROM Security
jumper is in the correct position if
doing a privileged-access password
install.
2. Retry the operation.
3. If retries do not solve the problem,
replace the I/O board. (See notes
on 3-1.)
25AA0000 Unable to unlock EEPROM. Refer to Action under error code
25AA0xxx.
25AA0001 Read-Recv error. Refer to Action under error code
25AA0xxx.
25AA0002 Read-Trans error. Refer to Action under error code
25AA0xxx.
25AA0003 Write-enable error. Refer to Action under error code
25AA0xxx.
25AA0004 Write-recv error. Refer to Action under error code
25AA0xxx.
25AA0005 Write-disable error. Refer to Action under error code
25AA0xxx.
25AA0006 Write-Trans error. Refer to Action under error code
25AA0xxx.
25AA0007 Unable to lock EEPROM. Refer to Action under error code
25AA0xxx.
25B00001 No memory modules detected in either
memory card 1 or 2.
1. Reseat any installed memory
card(s) and retry.
2. Reseat any installed memory
modules on the installed memory
cards.
3. Replace Memory Card(s).
25Cyyxxx Memory Card problems See “Memory PD Bits” on page 3-28
for definition of "yy".
Use the location code obtained from
the SMS Error Log utility (described in
MAP Step 1020-4) to identify which
memory module (or memory module
pair) the error is reported against.
Chapter 3. Error Code to FRU Index 3-9
To Next Page
Loading...
