IBM RS/6000 H50

Table 3-1 (Page 13 of 26). Firmware Error Codes.
Error Code Description Action / Possible Failing FRU
2BA00064 Service processor reports PCI riser
card VPD module not present.
Replace the PCI riser card.
2BA00065 Service processor reports PCI riser
card VPD data corrupted.
Replace the PCI riser card.
2BA00066 Service processor reports PCI expan-
sion card VPD module not present.
Replace the PCI expansion card.
2BA00067 Service processor reports PCI expan-
sion card VPD data corrupted.
Replace the PCI expansion card.
2BA00070 Service processor reports CPU card
VPD module not present.
Replace the CPU card(s).
2BA00071 VPD data corrupted for CPU in slot 0. Replace the CPU card in slot 0.
2BA00073 VPD data corrupted for CPU in slot 1. Replace the CPU card in slot 1.
2BA00100 Service processor firmware recovery
information could not be written to
diskette.
1. Check diskette media write protect
tab.
2. Replace the diskette drive.
2BA00101 Service processor is not installed,
update cancelled.
1. Install the service processor.
2. Retry operation.
2BA00102 No service processor update diskette in
drive.
Insert the diskette.
2BA00103 Service processor firmware update file
is corrupted, update cancelled.
1. Obtain new service processor
firmware diskette.
2. Retry operation.
2BA00104 Service processor firmware update file
is the same level as the service
processor firmware, update cancelled.
1. Obtain new level of service
processor firmware.
2. Retry operation.
2BA00200 Service processor firmware update
error occurred, update not completed.
Error occurred during service processor
flash write operation.
Service processor firmware update
error recovery procedure:
1. Turn the system Off.
2. Unplug power cable and then plug
power cable back in.
3. Turn the system On.
4. Retry operation. If problem per-
sists, replace service processor.
2BA00201 Service processor firmware update
error occurred, update not completed.
Error occurred while reading service
processor CRC.
See error code 2BA00200 for recovery
procedure.
2BA00202 Service processor firmware update
error occurred, update not completed.
Error occurred while verifying service
processor CRC.
See error code 2BA00200 for recovery
procedure.
3-14 RS/6000 Enterprise Server Model H50 Installation and Service Guide