To Next Page

To Previous Page

DRAFT

Procedures for enabling RAID or the AHCI mode

These procedures are for the Windows XP or 2000 CD-ROM installation.

1. Press Delete during BIOS power-on self-test (POST).

2. Select Integrated Peripherals and press Enter.

3. Select INTEL OnChip IDE Device and press Enter.

4. Select SATA mode and press Enter.

5. Select AHCI or RAID.

6. Select Save & Exit.

Note:

If you selected RAID mode, continue with these steps:

7. Follow the on-screen instructions to enter the RAID configuration utility during

BIOS POST.

8. Select Create RAID Volume and press Enter.

9. Name the new RAID Volume and press Enter.

10. Select the RAID mode of operation (RAID 0 or RAID 1).

11. Press Enter to use the entire hard drive for RAID.

12. Press Enter to verify that you want to create the RAID Volume.

13. Press Y to answer the question, Are you sure you want to create this

volume?

14. Press Esc to exit.

15. Press Y to answer the question, Are you sure you want to exit?

Updated October, 2007

4 SurePOS 700 Series: SurePOS 700-722/742/782, 723/743/783 Operating System Installation Guide

Other manuals for IBM SurePOS 700 Series

Questions and Answers:

Need help?

Do you have a question about the IBM SurePOS 700 Series and is the answer not in the manual?

General