IBM System/360 Field Engineering Manual

.--------------------· ------~------.
12. Each Customer Engineer is responsible to be certain that
no action on his part renders product unsafe or exposes
hazards to customer personnel.
13. Place removed machine covers in a safe out-of-the·-way
place where no one can trip over them.
14. All machine covers must be in place before machine is re·
turned to customer.
15. Always place CE tool kit away from walk areas where no
one can trip over it (i.e., under desk or table).
16. Avoid touching mechanical moving parts (i.e., when lubri-
cating, checking for play, etc.).
17. When using strobc1scope - do not touch ANYTHING - it
may be moving.
18. Avoid wearing loose clothing that may be caught in machin-
ery. Shirt sleeves must be left buttoned or rolled above the
elbow.
19. Ties must be tucked in shirt or have a tie clasp (preferably
nonconductive) approximately 3 inches from end. Tie chains
are not recommended.
20. Before starting equipment, make certain fellow CE's and
customer personnel are not in a hazardous position.
21. Maintain good housekeeping in area of machines while per·
forming and after completing maintenance.
(;) )>
z ~
; ~
~ §:
n
o:
z ..
6 "E.
m ..
"'g
~ ~·
0 ;,
z
"'

IBM System/360 Specifications

General

Brand	IBM
Model	System/360
Category	Desktop
Language	English