IBM System/360 User Manual

r--------------~-------------------------------------------------------,
TERMI NAL #7 I
(Available 9:00 a.m. - 3:00 p.m.
For additional time call A. Jones ext. 1234)
1.
TUrn ON/OFF switch to ON.
2.
Make sure the COM/LCL switch is set to COM.
3.
Remove handset from telephone (data set).
4. Press TALK button on telephon~.
5. Dial ext. 5555, 5556, or 5557.
6. Wait for a high pitched tone. When you hear this tone you
are in contact with the computer. If you get a busy signal
or no answer, hang up and repeat from step 3 trying another
extension.
7. Push the DATA button on the telephone. If DATA button light
goes off at any point during session, repeat from step 3.
8. Replace handset on the cradle.
9. Enter LOGON command:
logon_
t
_/ \ acct( __ ~( proc (-t-> size (-( [~:~~~es] [::!il]
userid password account procedure nnnn
10. The default TERMINAL command is:
terminal nolines noseconds noinput break notimeout linesize(120)
If you want to change any of the following defaults use this
TERMINAL command:
terminal lines{
) seconds (
)
input ( ) linesize (
11. If you want to change your user profile, use the PROFILE
command:
)
profile char(bs) l~ne(attn) no prompt
. [Char ( )] [line () ][promPt]
nochar I1ne(ctlx)
[
intercom 1 rpause 1 [ms9id 1
nointercomJ LnopauseJ nomsgi~
noline
The following operands are recommended for this terminal:
char (bs) and line (attn)
Note: Please turn ON/OFF switch to OFF after you enter LOGOFF.
I
I
I
I
I
I
I
I
I
I
L __ ~ ___________________________________________________________________ J
Figure 2. Sample Instruction Sheet for a Terminal
Your user attributes are recorded in the system together with the
attributes of all other terminal users. When you log on, the system
compares the attributes you specify in the LOGON command to the recorded
attributes of each user to determine if you are an authorized user of
the system.
22' TSO Terminal User's Guide (Release 21)

IBM System/360 Specifications

General

Brand	IBM
Model	System/360
Category	Desktop
Language	English