IBM System/360 User Manual

To replaqe characters after TUESDAY'S in line 30 of your data set .• you
can use the special-delimiter notation:
change 30 /tuesday's/
00030 THIS IS TUESDAY'S child
or the quoted-string notation:
change 30 'tuesday"s'
00030 THIS IS TUESDAY'S child
RENUMBERING LINES OF DATA
You can use the RENUM subcommand to assign line numbers to a data set
without line numbers, or to renumber the'iines of a data set with line
numbers.. If you enter:
renum
the system assigns new line numbers to all the lines of the data set.
The firs~ line will be assigned the number 10 and subsequent lines will
be incremented by 10.
You can assign a number to the first line of the data set. For
example, if you want the first line to have number 5, enter the
following:
renum 5
The remaining line numbers will be 15.,25,,35, etc.
You can specify an increment other than 10 in addition to the number
of the first line. For example if you want the first line to be number
one.,
and the remaining line numbers to increase by 3., enter:
renum 1 3
If your data set already has line numbers you can specify that
renumbering is to start at a given line. You must also specify the new
number
for this line (which must be equal to or greater than the old
line number) and the increment. For example, if you want to start
renumbering at line 23, and the new·line number is to be 25 and the
increment is 'to be 5, enter:
renum 25 5 23
If you use the RENUM subcommand to renumber your data set, the
renumber increment that you specify is used when you enter the INPUT
subcommand the next time during the Edit session. For example, if the
following sequence occurred:
list
00010 LINE 1 OF DATA
00020 LINE 2 OF DATA
00030 LINE 3 OF DATA
END OF DATA
renum 3 3
input
INPUT
00012 line 4 of data
00015 line 5 of data
00018 (null line)
EDIT
Entering and Manipulating Data 49

IBM System/360 Specifications

General

Brand	IBM
Model	System/360
Category	Desktop
Language	English