IBM System/360 User Manual

The FIND subcamnand starts looking for the sequence of characters
beginning with the line at which the pointer. is located.. Therefore,
unless you are sure the characters are in a line following the one
indicated by the pointer~ you should use the TOP subcommand to move the
pointer to the beginning of the data set. For example:
top
find xplaced before entry
Figure 6 shows a data set used to illustrate the examples of
positioning the current line pointer. Although this data set has line
numbers" they are not used in the examples.
r----------------------------------------------------------------------,
I 00010 TEMPERATURE DATA FOR 7/29/70 I
I 00020 HIGHEST, 90 AT 12:30 P.M. I
I 00030 LOWEST, 73 AT 5:40 A.M. I
I 00040 MEAN, 83 I
I 00050 NORMAL ON THIS DATE, 77 I
I 00060 DEPARTURE FROM NORMAL, +6 I
I 00070 HIGHEST TEMPERATURE THIS DATE, 99 IN 1949 I
I
00080 LOWEST TEMPERATURE THIS DATE, 59 IN 1914 I
I
00090 TEMPERATURE HUMIDITY INDEX., 81 I
L __________________________________________________ ~ ___________________ J
Figure 6. Sample Data Set
Assume that you do not know the present location of the current line
pointer, and would like to move it to the' fifth line (00050). Enter:
top
down 5
To move the pointer from the fifth line (00050) to the third line
(00030), enter:
up 2
To move the pointer to the line that contains FROM NORMAL enter:
find xfrom normal
To move the pointer to the last line (00090), enter:
bottom
Updating a Data Set
The subcommands of the EDIT command all,ow you to update a data set.
That is:, they allow you to:
• Delete data from a data set.
• Insert data in a data set.
• Replace data in a data set.
• Renumber lines of a data set.
These functions are described in the following paragraphs.
40 TSO Terminal User's Guide (Release 21)

IBM System/360 Specifications

General

Brand	IBM
Model	System/360
Category	Desktop
Language	English