IBM System/360 User Manual

r---------------------T------------------------------------------------,
I Edit Subcommands I Value of the Pointer at Completion of Subcommand I
.-~-------------------+-------------------------------------~----------f
BOTTOM I Last line (or line zero for empty data sets)
I
CHANGE I Last 1 ine changed
I
DELETE ILine preceding deleted line, if any, else zero
I
DOWN I The 1 ine n down trom where you were at the start
lof the subcommand, or the bottom of the data
I set. (n is the value of the 'count' parameter.)
I
END INo change
I
FIND IFound line, if any, else no change
I
HELP INo change
I
INPUT I Last 1 ine entered
I
INSERT ILast line entered
I
Insert/Replace/Delete Inserted or replaced line, or line preceding the
deleted line. if any. or else zero.
ILIST
I
Last line listed
I PROFILE
No change
I
IRENUM
Same relative record
I
RUN
No change
SAVE
No change
SCAN
Last line referred to, if any
TABSET INo change
I
TOP I Zero value
I
UP IThe line n lines up from where you were at the
Istart of the subcommand, or the top of the data
I set. (n is the value of the 'count' parameter.)
I
I VERIFY INo change
L _____________________ ~ ________________________________________________ J
Figure 5. Values of the Line Pointer Referred to by an Asterisk (*)
POSITIONING THE CURRENT LINE POINTER
You can use the UP, DOWN, TOP, BOTTOM and FIND subcommands to move the
current line pointer.
The UP subcommand moves the pointer a specified number of lines up,
relative to the beginning of your data set. For example, to move the
pointer so that it refers to a line located five lines before the
location currently referred to. enter:
up 5
38 TSO Terminal User's Guide (Release 21)

IBM System/360 Specifications

General

Brand	IBM
Model	System/360
Category	Desktop
Language	English