EasyManuals Logo

IBM System x3250 Installation Guide

IBM System x3250
76 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #28 background imageLoading...
Page #28 background image
v The adapter slots are on the riser-card assembly. You must first remove the
riser-card assembly to access the adapter slots.
v The two PCI Express slots on the riser-card assembly support PCI Express x8
1.0a adapters.
v You can install one full-height three-quarter-length adapter in expansion slot 1
and one low-profile half-length adapter in expansion slot 2.
v The optional Remote Supervisor Adapter II SlimLine can be installed only in the
dedicated connector on the system board (see “System-board optional-device
connectors” on page 6 for the location of the connector). To install the Remote
Supervisor Adapter II SlimLine, see “Installing a Remote Supervisor Adapter II
SlimLine” on page 17.
v The server uses a rotational interrupt technique to configure PCI Express
adapters so that you can install PCI Express adapters that do not support
sharing of interrupts.
v An optional ServeRAID
8s controller provides RAID level 5 support to the
hot-swap drives. A ServeRAID 8s controller supports the 2.5-inch hard disk drives
without modification. To use a ServeRAID 8s controller with hot-swap 3.5-inch
drives, you must connect it to the hard disk drive backplane with a SAS signal
cable that is 58 cm (22.8 in.) long. See http://www.ibm.com/servers/eserver/
serverproven/compat/us/ for information about ordering the cable.
v An optional IBM SAS HBA Controller adapter enables you to connect external
storage devices, such as SAS or SATA hard disk drives or tape drives, to a
simple-swap SATA model server.
v The server scans the PCI slots to assign system resources. The scan sequence
is related to the startup sequence. If you have not changed the default startup
sequence, the server scans the PCI slots in the following order: the integrated
Ethernet controllers 1 and 2; then, the drives connected to the SAS/SATA
controller; then, the PCI Express slots 1 and 2.
Riser-card
assembly
Adapter support
bracket
Adapter
Expansion slot 1
Expansion slot 2
Expansion-slot
bracket
14 IBM System x3250 Types 4364 and 4365: Installation Guide

Table of Contents

Other manuals for IBM System x3250

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the IBM System x3250 and is the answer not in the manual?

IBM System x3250 Specifications

General IconGeneral
Processor Sockets1
Memory Slots4
ProcessorIntel Core 2 Duo
StorageSATA
Maximum Internal StorageUp to 4TB
Hard Drive InterfaceSATA
RAID SupportRAID 0, 1
NetworkGigabit Ethernet
Operating System SupportWindows Server, Linux

Related product manuals