ICA ce 1200 User Manual

ICA

ICA ce 1200 Specifications

General

Brand	ICA
Model	ce 1200
Category	UPS
Language	English

Summary

I. INTRODUCTION / PENDAHULUAN

II. TECHNICAL SPECIFICATION / SPESIFIKASI TEKNIK

III. FRONT PANEL & REAR PANEL VIEW / TAMPAK PANEL DEPAN & PANEL BELAKANG ELAKANG

IV. UPS INSTALLATION / PEMASANGAN UPS

Location selection

Instructions for selecting a protected location for the UPS installation.

Installation

Steps for connecting the UPS to a power receptacle with earth ground.

Communication software installation (optional)

Guide for installing communication software for UPS monitoring.

V. OPERATION PROCEDURE / CARA MENGOPERASIKAN

Turn on procedure

Steps to turn on the UPS and connected loads.

When the line power is interrupted

Describes UPS operation during line power failure and battery status.

Turn off procedure

Instructions for safely turning off the UPS and its connected loads.

VI. START UP UPS / MENGHIDUPKAN UPS

Make sure Main Switch on the "off" position and no load is connected to the outlet.

Ensures the main switch is off and no load is connected before startup.

Connect inlet with power cord to a power receptacle with earth ground

Connects the UPS power cord to an earthed power outlet.

Turn on the UPS by pressing power button.

Initiates the UPS startup sequence by pressing the power button.

Disconnect inlet from line power, the green led of LINE ON will go out while the yellow led of INVERTER will light on and audible alarm will sound every 4 seconds.

Tests inverter operation by disconnecting line power, indicated by LEDs and alarm.

Connect inlet to line power again and then after about 2 seconds the yellow led of INVERTER will go out while the green led of line on will light on.

Restores normal operation by reconnecting line power, indicated by LEDs.

Now your UPS is ready for operation. Connect the equipment that is going to be supplied by the UPS into the UPS.

Confirms UPS readiness and instructs to connect the equipment to be powered.