ICA SE3000 - User Manual

Questions and Answers

A
Alexander DiazAug 8, 2025
Why does my ICA SE3000 have short backup time?
- L
  lawrencelouisAug 8, 2025
  If your ICA UPS experiences short backup time, it could be due to several reasons. First, the battery may not be charged enough; keep the UPS connected to utility power for more than 8 hours to recharge it. Second, the UPS might be overloaded; check the load capacity and remove any unnecessary devices. Finally, the battery could be old; in this case, remove the battery and contact your franchiser for a replacement and related subassembly.
L
Laura SmithAug 16, 2025
What to do if ICA SE3000 doesn’t startup after pressing the ON button?
- J
  James EstesAug 16, 2025
  If your ICA UPS doesn't start after pressing the ON button, ensure you press and hold the button for more than 1 second. Also, check that the battery is properly connected and has sufficient voltage. If the battery voltage is low, turn off the UPS, disconnect some loads, and then try starting it again. If the issue persists, there may be an internal fault, and you should contact your supplier for servicing.
C
cwilliamsAug 25, 2025
What to do if battery indicator flashes on ICA SE3000?
- K
  Krystal WoodsAug 25, 2025
  If the battery indicator on your ICA UPS is flashing, it means that the battery voltage is low or the battery is not connected properly. Check the UPS battery, reconnect it securely, and if the battery is damaged, replace it.
S
Stephanie SalazarAug 30, 2025
Why utility normal, but ICA SE3000 UPS has no input?
- L
  lucasmichaelAug 30, 2025
  If your ICA UPS shows normal utility input but has no input, it is possible that the UPS input breaker is open. You should manually reset the breaker.

Summary

Appendix Specification

Introduction

Troubleshooting

Information Table

Table listing fault codes, their modes, and corresponding status indicators.

Safety

Installation

UPS Receipt and Inspection

Instructions for unpacking, inspecting the UPS for damage, and verifying the model.

Safety Notes

Precautions for UPS placement, ventilation, temperature, and electrical connections.

Maintenance

Fault Mode Operation

UPS Rear Panel Description

Battery Mode Operation

Utility Mode Operation

Front Panel and Display Lamp Description

LCD Panel Section Details

Explains the four lines of the LCD panel: numeric, item, graphic, and status sections.

LED Indicator Functions

Describes the meaning of the red, yellow, and green LED indicators on the UPS.

Button Part Functions

Details the functions of the START/OFF, FUNCTION, and INQUIRING buttons on the UPS.

Button Part Functions (Continued)

Operation and Running

General Operation

Simple operation instructions, no special training required for operators.

Operation in Utility Mode

Steps to turn on the UPS in utility mode, including self-test and status indication.

Startup UPS with DC Input (Cold Start)

Procedure for cold starting the UPS using battery power when utility power is absent.

Turn Off UPS in Utility Mode

Turn Off UPS in Battery Mode

UPS Self-Test and Mute Test Operation

Run Modes Overview

Bypass Mode

Conditions for entering bypass mode and its implications for load power supply.

ICA SE3000 Specifications

General

Operating Temperature	0-40 °C
Storage Temperature	-15-45 °C
Input Voltage	230V
Input Frequency	50/60Hz
Output Voltage	230V
Output Frequency	50/60Hz
Typical Recharge Time	4-6 hours
Protection	Overload
Interface	USB
Humidity	0-90% non-condensing