Ice EXTREME AIR FX - Leg Installation; Assembling Legs and Feet; Securing Legs to Cabinet

7
Leg Assembly:
Aer removing the legs from the cabinet, remove the bolt using a 6mm Allen wrench on each leg. You will
have to also use a wrench to hold the adjustment rod from spinning out. Then place one feet per leg and
reaach the 6mm bolt. The adjustment rods are installed from the factory and can be adjusted for uneven
heights once installed to the cabinet.
X’s 4 per leg, 16 total.
Aaching the assembled Legs:
Using four 7/16 bolts and washers aach each leg onto the boom of the cabinet. Tighten all bolts.