The Free Game Opon
An excing feature allows the operator to award a free game in place of paying ckets. To enable this
feature you must set the opon “Free game mode” to “on”. When it is enabled the cket mechanism will no
longer pay ckets. If the player wins the bonus round, the player will be able to play another game without
pung coins to start.
Step 1: If not already unlock and open the upper coin door. Press the “TEST” buon. This will cause the up-
per display on the game to change to “TEST”.
NOTE: The small display inside the coin door will display the test and program menus. Press the “SRV”
buon to go to the next opon or menu. Press the “TEST” buon to select that opon or menu.
Step 2: If not already, press “SRV” unl the menu shows “8.Game SETTINGS”.
Step 3: Press “TEST” to select this menu group.
Step 4: Press “SRV” unl it shows “Free Game Mode”.
Step 9: Press “TEST” to change the value to “ENABLE”.
Step 10: Press “SRV” unl it shows “Exit Game Sengs”
Step 11: Press “TEST”
Step 12: Press “SRV” to change N to Y.
Step 13: Press “TEST” to exit and accept.
Adjusng The Ticket Value
The game by default values each cket as .01. Unless you ordered your game otherwise, if you cket value is
dierent, you must change the opon “Set Ticket Value” to the correct value. Valid values are .001, .002,
.005, .01, .02, .03, .04, .05, .06, .07, .08, .09, or .10.
Step 1: If not already unlock and open the upper coin door. Press the “TEST” buon. This will cause the up-
per display on the game to change to “TEST”.
NOTE: The small display inside the coin door will display the test and program menus. Press the “SRV”
buon to go to the next opon or menu. Press the “TEST” buon to select that opon or menu.
Step 2: If not already, press “SRV” unl the menu shows “8.Game SETTINGS”.
Step 3: Press “TEST” to select this menu group.
Step 4: Press “SRV” unl it shows “Set Ticket Value”.
Step 9: Press “TEST” to change the value to the correct cket value.
Step 10: Press “SRV” unl it shows “Exit Game Sengs”
Step 11: Press “TEST”
Step 12: Press “SRV” to change N to Y.
Step 13: Press “TEST” to exit and accept.