Ice Hoopla - Set Date;Time

Aract Audio Sounds
You can disable the aract audio while the game awaits to be played.
Step 1: If not already unlock and open the upper coin door. Press the “TEST” buon. This will cause the up-
per display on the game to change to “TEST”.
NOTE: The small display inside the coin door will display the test and program menus. Press the “SRV”
buon to go to the next opon or menu. Press the “TEST” buon to select that opon or menu.
Step 2: If not already, press “SRV” unl the menu shows “8.Auido SETTINGS”.
Step 3: Press “TEST” to select this menu group.
Step 4: Press “SRV” unl it shows “Audio in Aract”.
Step 9: Press “TEST” to change the value to “o”.
Step 10: Press “SRV” unl it shows “Exit Audio Sengs”
Step 11: Press “TEST”
SET DATE/TIME
If the baery has been replaced or the me date is incorrect follow the next few steps to correct it.
Step 1: If not already unlock and open the upper coin door. Press the “TEST” buon. This will cause the up-
per display on the game to change to “TEST”.
NOTE: The small display inside the coin door will display the test and program menus. Press the “SRV”
buon to go to the next opon or menu. Press the “TEST” buon to select that opon or menu.
Step 2: If not already, press “SRV” unl the menu shows “10.SET DATE/TIME”.
Pressing TEST once will acvate the Date/Time seng and place a ashing cursor underneath the rst eld
(DATE)
Pressing the SERVICE buon will move the cursor along the elds in the following sequence: DATE →
MONTH → YEAR → HOUR → MINUTE → EXIT.
When on a eld, pressing the TEST buon will advance the value by 1. Pressing and holding TEST for longer
than 1 second will increment the value every 0.25 seconds.
The range for the DATE eld will be between 1 and 28, 29, 30 or 31 (depending on the MONTH and YEAR
elds)
The range for the MONTH eld will be between 1 and 12
The range for the YEAR eld will be between 1 and 99.
The range for the HOUR eld will be between 00 and 23.
The range for the MINUTE eld will be between 00 and 59
If the HOUR or MINUTES elds are modied , the internal seconds count is set to zero.