To Next Page

To Previous Page

MACHINE SET UP & INSTALLATION

ICE i18B/i18C

OPERATOR MANUAL

UNPACK MACHINE:

Be sure and check packing carton for any damage. Immediately report any damage to carrier.

Be careful not to let machine vibrate while carrying, Check contents of package to ensure that

the following items are included: Machine, squeegee assembly, brush/pad driver, charger cord.

1) Sweep the outside of the machine.

2) Check battery meter to make sure batteries are fully charged (see battery charging, only for

i18B ).

3) Check that squeegee and brush / pad is properly installed.

4) The forward speed of machine can be controlled by turning the handle(10). Turn the handle

clockwise to speed up machine. or turn the handle anticlockwise to slow down machine.

5) Make sure the working surface can support the machine weight, the gradient of the oor can’t

exceed the limit that machine allowed(2%).

INSTALLING THE SQUEEGEE:

1) Loosen the two knobs(18) on the squeegee and slide the squeegee into the slots at the rear

of the squeegee bracket. (the wheels on the squeegee point to the machine.)

2) Tighten the knobs securely.

MACHINE SET UP & PRE-OPERATION CHECKS:

INSTALLING PAD DRIVER OR BRUSH:

1) Turn off machine.

2) Tilt the machine backwards, line up the driving hub with the hole of brush or pad driver, make

sure the three blocks are tted into the three slots of the drive hub.

*If a pad driver is being used, the appropriate pad should be attached to the pad driver rst.

3) Push the plunger which on the brush cover to prevent the driving hub from rotating,then spin

the brush/pad clockwise with your another hand till the clip clamp the block on the brush/pad.

FILLING THE SOLUTION TANK:

1) The ll port is located at the rear of machine,pull the plug out of the hole.

2) Fill solution tank with water. (use a hose which link to a water faucet,water temperature

should not exceed 50° C) The clear tube(19) in the back right of the machine has gallon

markers to help determine the water level in the solution tank(5).

*Depending on the dirty level of the ground, add the proper amount of detergent into the

solution tank.

Do not put any flammable materials into solution tank. This can cause an

explosion or a fire. Only use recommended cleaning chemicals. Contact

your janitorial supply distributor for recommendations on proper chemicals.

Ice I18B Operator's & Parts Manual

Other manuals for Ice I18B