ICE I18B/I18C
9
OPERATOR MANUAL
the drain hose plug to begin the draining process.
2) Clean the recovery tank after every use. Use a fresh water hose to rinse out the recovery
If you are storing the machine for any period of time, keep the cover tank open
so the tank can dry completely and smell fresh.
DRAINING THE RECOVERY (DIRTY) TANK
DRAINING THE SOLUTION (CLEAN) TANK
Any time scrubbing operation is completed, the solution tank should be drained
and cleaned.
1) Pull down on the clear tube (back left of the machine) to remove it from the hose barb. This
2) Rinse the solution tank with clean water after every use. This will help prevent chemical
buildup and clogging of the solution lines.
the tube is pushed all the way up on the hose barb.
screen, clean it up if necessary.
correct position.
BATTERY CHARGING (ONLY FOR I18B)
WARNNING: Fire or explosion hazard. Batteries may emit hydrogen gas. Keep
sparks and open flame away. Keep battery compartment open when charging.
NOTE:
- Automatic shut off circuit.
- Deep cycle charging.
- Output current of 8-15 Amps.
- Output voltage of 24 volts.
Each machine was equipped with on-board charger and batteries, please use oringinal parts
only.
To Next Page
Loading...
Need help?
General
