Ice Whack N Win - Page 6

6
Step 5:
While holding the upper light housing remove the two 1/4-20 x 1-1/4 screws using a # 3 Phillips screw
driver on each side and slide the light housing down being careful not to pinch any of the wire harnesses.
Aach the light housing using four at screws on each side (only one side is shown in the diagram).
Step 6:
Before liing the bonus marquee up to the top, open the access door using a 45 key. Put the door aside.
Slide the marquee assembly onto the top of the light housing and connect the harness shown below.