Need help?Do you have a question about the icetro IM-0460-AH-22 and is the answer not in the manual?
Outlines criteria for location selection and necessary clearances for operation.
Explains maximum allowable length, rise, and drop for line sets.
Provides formulas and steps to calculate total allowable line set distance.
Covers general cleaning and sanitizing procedures for the ice machine.
Outlines checks to ensure proper operation of the ice machine.
Details how to check and adjust ice thickness.
Explains the operational sequence for self-contained models.
Explains the operational sequence for remote air-cooled condenser models.
Details specific error codes, their causes, and troubleshooting steps.
Provides procedures for analyzing hot gas valve function.
Describes valve issues not maintaining discharge pressure.
Lists causes for high discharge pressure and hot liquid line.
Lists causes for low discharge pressure and warm/hot liquid line.
Recommends replacing the hot gas valve if leaking.
Discusses low charge and TXV starving issues.
Discusses TXV flooding and refrigerant overcharge issues.
Explains PCB function, standby mode, and operational sequences.
Explains the function, specifications, and check procedure for the main fuse.
Explains the bin switch function, specifications, and diagnostics.
Explains the water level probe function and specifications.
Explains the function and specifications of the ice thickness probe.
Covers checking compressor resistance and windings.
Explains the importance of correct refrigerant charge and symptoms of incorrect amounts.
Lists symptoms of undercharged and overcharged refrigerant in remote condensers.
Details refrigerant recovery/evacuation for self-contained models.
Details refrigerant recovery/evacuation for remote condenser models.
Explains the necessary connections for remote system recovery/evacuation.
Lists steps for remote condenser recovery/evacuation.
Introduces requirements for restoring contaminated systems.
Explains how to determine the severity of system contamination.
Provides a chart linking symptoms to required cleanup procedures.
Introduces charts used to verify ice machine operation and pressures.
States that the next page contains an electrical wiring diagram.
Shows the refrigeration tubing schematic for self-contained models.
Shows the refrigeration tubing schematic for remote condenser models.
To Next Page
General