Need help?Do you have a question about the Icom IC-970A and is the answer not in the manual?
General| Antenna Impedance | 50 Ω |
|---|---|
| Power Supply Requirement | 13.8 V DC ±15% |
| Voltage | 13.8 V DC |
| Mode | FM, SSB, CW |
| Selectivity | 15 kHz (-6 dB), 30 kHz (-60 dB) |
| IF Frequencies | 455 kHz |
| Frequency Range | 144-146 MHz, 430-450 MHz |
| RF Output Power | 10 W (VHF), 10 W (UHF), 5 W (SHF) |
Identifies and describes the main control switches, indicators, and connectors on the front panel.
Details the various input/output jacks and connectors located on the rear of the transceiver.
Covers unpacking, setting location, antenna connectors, and required connections.
Explains how to connect internal and external power supplies for the transceiver.
Describes VFO, CALL CHANNEL, and SATELLITE modes for frequency operation and band selection.
Explains VFO exchange, equalization, quick memory use, and direct frequency entry via keyboard.
Guides on setting switches and controls for basic receiving operations and dual watch.
Guides on transmitting in CW mode, including break-in operation and optional electronic keyer use.
Provides a comprehensive troubleshooting guide for power, receive, transmit, and display issues.
To Next Page
