Do you have a question about the Icom IC-F110 and is the answer not in the manual?
Frequency Range | 136-174 MHz |
---|---|
Power Output | 25W |
Channel Capacity | 16 channels |
Dimensions | 58 x 130 x 36 mm (without antenna) |
Weight | 350 g (with battery) |
Number of Channels | 16 |
Mode | FM |
Operating Voltage | 13.8V DC (±15%) |
Channel Spacing | 12.5 / 25 kHz |
Voltage | 13.8V DC (±15%) |
Describes the UP/DOWN keys for channel selection and the POWER switch for ON/OFF and mode access.
Explains the transceiver's function display and the meaning of various indicators like busy, signal strength, and scrambler.
Details the operation and assignment possibilities for programmable function keys like CH UP/DOWN, BANK, and P0-P3.
Covers the operation of MONITOR key for muting/unmuting and LOCK key for key locking.
Explains CALL, EMERGENCY, HOOK SCAN, and TX CODE keys for communication and transmission control.
Details how to enter and use the User Set Mode via the SET key for configuration.
Details transmit inhibit functions, time-out timer, and penalty timer, which restrict transmission under certain conditions.
Explains how to transmit DTMF codes using the DTMF key, including selecting channels and transmitting codes.
Describes the use of optional voice scrambler units (UT-109/UT-110) for private communication with matching scrambler codes.
Covers making telephone calls and calling other local system subscribers with specific key sequences.
Details system busy signals, PTT dispatch operation, emergency call initiation, and clear channel alerting.
Details the correct DC power connection to a 12V battery, with critical warnings about fuse holder and voltage.
Lists included accessories and explains the use of function name stickers for programmable key identification.
Provides instructions for installing optional units like UT-105, UT-108, or UT-111 into the transceiver.
Guides the installation of the OPC-617 cable, including pin assignment details and bushing modification.