10
2
OPERATION
D User set mode
User set mode is accessed at power ON and allows you to
set seldom-changed settings. In this case you can “cus-
tomize” transceiver operation to suit your preferences and
operating style.
Entering the user set mode:
q While pushing and holding []and [], push [POWER]
to enter user set mode ON, allowing you to set seldom-
changed settings.
w Push and hold [P0] to select the appropriate item. Then,
push []or []to set the desired level/mode.
- Available set mode functions;
• Backlight : OFF, Dim, Auto or ON
• Beep : OFF or ON
• SQL Level : 0 to 255
• AF Min level : 0 to 255
e Push [POWER] (or push and hold [P0]) again to exit set
mode.
User set mode is also available via a programmable key.
Please refer to p. 6 [SET] section.
IC-F110_F210_EUR-1.qxd 03.2.5 3:31 PM Page 10 (1,1)
To Next Page
Loading...
