<>
Turbo SpeeDial
To
automatically
dial a
commonly
used
number
with
one
push:
Push one of the turbo SpeeDials ([A], [B], [C]
or
[D]).
<>
Programming memory speed dial
CD
Push and hold
[*1
until you hear a
high
..
pitched beep.
® Enter the memory location
(0-9,
A,
B,
C,
D), the telephone
or subscriber number, then
[1
] (or [3] if for another system
subscriber); then push
[*1
to complete the programming
sequence.
• A high-pitched beep indicates successful programming.
• Memories [A]-[D] are used for the Turbo SpeeDial.
<>
System
busy
indication
If all channels are busy, three low beeps sound after you initi-
ate a call.
Try the call again later.
<>
PTT dispatch operation
CD
Push [PTT] once (without dialing) to initiate a dispatch call.
® Begin talking after you hear three beeps (one short, high-
pitched, two very-short, low-pitched).
® Receiving a dispatch call is indicated
by
the same three-
beep sequence.
·It
is not necessary to push
[*J
to answer a dispatch call.
OPTIONAL SmarTrunk IllM OPERATION 4
<>
Emergency call
Push [0],
[*1
to initiate an emergency call.
• Contact your dealer for details.
<>
Clear channel alerting
If all channels are busy, the transceiver automatically begins
searching for an open channel and beeps every ten seconds.
When two short beeps (low-pitched, then high-pitched) are
heard, a channel is available. Push
[*J,
[*1
immediately to
re-
dial the last number.
Note:
For
additional operating instructions,
contact
your
dealer
or
system operator.
12
To Next Page
Loading...
Need help?
General
