■ Channel selection
Several types are available, and the channel selection
method may differ according to your system set up.
NON-BANK TYPE:
Push the []/[]keys to select the desired operating
channel, in sequence; or,
push one of the [
CH 1] to [CH 4] keys to select these channels
directly.
Select indicator LED lights when CH5 to CH8 is selected.
(PMR 8CH model)
BANK-TYPE: (PMR)
Push [
BANK] to select the desired bank number.
Select indicator LED lights when bank 2 is selected.
AUTOMATIC SCAN TYPE:
Channel setting is not necessary for this type. When turning
the power ON, the transceiver automatically starts scanning.
Scanning stops when receiving a call or when taking the mi-
crophone off hook.
■ Turning power ON
q Push [K
I
] to turn the power ON.
w If the transceiver is programmed for a start up passcode,
input digit codes as directed by your System operator.
• The keys in the diagram below can be used for password input:
• The transceiver detects numbers in the same block as identical.
Therefore “1234” and “6789” are the same.
e When all channel indicator LEDs still blink after inputting 4
digits, the input code number may be incorrect. Turn
power off and start over in this case.
OPERATION
2
6
To Next Page
Loading...
