8
OPTIONAL UNIT INSTALLATION
23
You can install two of the following optional units in the transceiver.
UT-105
SmarTrunk II
TM
Logic Board
, UT-109/UT-110
VOICE SCRAMBLER
UNIT
, UT-111
TRUNKING BOARD
, UT-113
MAN DOWN UNIT
.
‘‘
Installation
q Unscrew nut a, and remove the knobs.
w Unscrew screw b and 2 screws c, then remove the multi-con-
nector cover and rear panel.
e Unscrew 2 screws d, then remove the multi-connector.
r Unscrew 2 screws e, then take off the chassis from the front
panel in the direction of the arrow.
Be careful!: Flat cable is connected between the MAIN unit on the
chassis and front panel.
t
Install the desired optional unit. Insert tightly to avoid bad contact.
NOTE: When installing
UT-105 or UT-111, the
unit MUST BE pluged
into SLOT 1. Otherwise
the unit will not work cor-
rectly.
(Other optional units
can be plugged into either
slot.)
y
Program the necessary information with the cloning software before
operation. Please ask your dealer or system operator for details.
To Next Page
Loading...
