CE Versions of the IC-F310/S which display the
“CE” symbol on the serial number seal, comply with
the essential requirements of the European Radio
and Telecommunication Terminal Directive
1999/5/EC.
This warning symbol indicates that this equipment
operates in non-harmonised frequency bands
and/or may be subject to licensing conditions in the
country of use. Be sure to check that you have the
correct version of this radio or the correct program-
ming of this radio, to comply with national licensing
requirement.
<Intended Country of Use>
■■ GER ■■ NED ■■ ITA
■■ AUT ■■ BEL ■■ GRE
■■ GBR ■■ LUX ■■ SWE
■■ IRL ■■ ESP ■■ DEN
■■ FRA ■■ POR ■■ FIN
55-#54,58,59/ 66-#54,59 A -5458D-4EU
INSTALLATION NOTES
The installation of this equipment should be made in such a manner
as to respect the EC recommended electromagnetic field exposure
limits (1999/519/EC).
The maximum RF power available from this device is 25 watts. The
antenna should be installed as high as possible for maximum effi-
ciency and that this installation height should be at least 5 meters
above ground (or accessible) level. In the case where an antenna
cannot be installed at a reasonable height, then the transmitter should
neither be continuously operated for long periods if any person is
within 5 meters of the antenna, nor operated at all if any person is
touching the antenna.
In all cases any possible risk depends on the transmitter being acti-
vated for long periods. (actual recommendation limits are specified
as an average of 6 minutes) Normally the transmitter is not active for
long periods of time. Some radio licenses will require that a timer cir-
cuit automatically cuts the transmitter after 1–2 minutes etc.
Similarly some types of transmitter, SSB, CW, AM, etc. have a lower
‘average’ output power and the perceived risk is even lower.
ABOUT CE
To Next Page
Loading...
