Need help?Do you have a question about the Icom ic-f5026/h and is the answer not in the manual?
General| Brand | Icom |
|---|---|
| Model | ic-f5026/h |
| Category | Transceiver |
| Language | English |
Identifies components on the top view of the front unit's PCB.
Identifies components on the top view of the main-A unit's PCB.
Identifies components on the bottom view of the main-A unit's PCB.
Step-by-step guide for installing the optional UT-108 unit.
Step-by-step guide for installing the optional OPC-1939 cable.
Step-by-step guide for installing optional UT-109R or UT-110R units.
Details the receiver signal path, including RF, 1st IF, and 2nd IF stages.
Explains the transmitter signal path, including MIC amp, TX AF, and TX amplifiers.
Describes the operation of VCOs and PLL for frequency control.
Illustrates power distribution throughout the transceiver.
Lists pin assignments for CPU, Expander, and D/A converters.
Lists necessary equipment and preparation steps for adjustments.
Details the steps for adjusting frequencies and PLL lock voltages.
Covers adjustments for output power, modulation balance, and deviation.
Details adjustments for receive sensitivity, S-meter, and squelch.
Lists mechanical parts for the chassis and included accessories.
Lists mechanical parts specific to the front and main-A units.
Visual layout of components on the main-A unit's PC boards (top and bottom).
Visual layout of components on the front unit's PC board (top and bottom).
Illustrates the general wiring connections for front and main-A units.
Details the pin assignment for the optional OPC-1939 cable.
Shows voltage distribution within the front unit.
Details voltage distribution across the main unit.
To Next Page
